Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Terence Tam

Edit approved by Terence Tam

Before
After
Unchanged

Step Lines

+[title] Verify End Stop Operation ΒΆ
+[* black] Pull the end effector downwards to move the carriage away from the end stops.
+[* black] In MatterControl, expose the GCode terminal by clicking on the Configuration Tab, then click "Show Terminal"
+[* black] In the terminal that will open, type "M119" and hit ENTER.
+[* black] M119 is a GCode command, telling the printer to report its end stop status. You are looking to see a message that tells you that XMAX, YMAX and ZMAX are OPEN.