All fans should be installed with label side facing inwards.
Look for the absent of a plastic peg holding the fan, that is the corner that the wires should go.
Thread thee red and black cable through the small hole on the end effector top housing.
Secure fans with M2 x 16mm SHCS and M2 nuts.
Dab a bit of Loctite 410 on the inside threads of the end effector fans to prevent the screws from loosening during operation.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.