Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Pull the end effector downwards to move the carriage away from the end stops.

In MatterControl, expose the GCode terminal by clicking on the Configuration Tab, then click "Show Terminal"

In the terminal that will open, type "M119" and hit ENTER.

M119 is a GCode command, telling the printer to report its end stop status. You are looking to see a message that tells you that XMAX, YMAX and ZMAX are OPEN.

Your contributions are licensed under the open source Creative Commons license.