Skip to main content

Site Navigation

Your Account

Choose Language


Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Now, move the X carriage up until you can hear the end stop switch click.

Run M119 again. (Note, you can just hit Up Arrow to repeat the command, and press enter)

You should see a message that says XMAX has been triggered, while YMAX and ZMax remain open.

Repeat this procedure, one carriage at a time, for Y and Z axis.

Your contributions are licensed under the open source Creative Commons license.