Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 11 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Now let we've verified that the printer moves, let's check the end effector.

One fan should be on; this is the fan that blows into the heat break on the hot end.

Two other fans should be off.

In the "Controls" tab of MatterControl, under "Extruder Temperature", verify that the temperature being read is non-zero and a reasonable (15-30 deg C, depending on your ambient temperature) value.

Troubleshooting: If temperature reads zero, it indicates a broken connection to the hot end thermistor. If the temperature reads overly high (>500 deg C), it indicates a short on the thermistor wiring.

Your contributions are licensed under the open source Creative Commons license.