Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 13 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

With the hot end at temperature, now it's time to test the extruder motor

Note: The firmware contains a lockout to stop the extruder motor if the hot end temperature drops, to prevent putting excessive pressure on the hot end.

Under movement control, select 10mm, then extrude 10mm

Verify that the motor spins on the extruder motor and that it is spinning in the correct direction.

Your contributions are licensed under the open source Creative Commons license.