Like every T-Slot construction system, it is necessary to pre-plan the insertion of extra nuts for future expansion.
Faces highlighted have their ends capped off after assembly, and it is a good idea to insert additional nuts into these channels PRIOR to assembling the subassembly.
The only exception is the face highlighted in blue. This face will be used for electronics mounting. Here, insert 2x M3 x 10mm or M3 x 6mm hex head cap screws, found in the Brainwave Pro mount accessory pack, in Kossel Common Core Components kit.
We suggest inserting a minimum of 6 M3 nuts, to allow for the addition of 2 OpenBeam brackets. You have been supplied with a copious amount of M3 nuts and you may insert more.
Using the provided set screws, secure the stack of nuts in the center of each extrusion face as shown on the right to prevent rattling and the nuts falling out while maneuvering the extrusion during the build process.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.