The distance between the flange of the timing belt pulley and the flange highlighted on the stepper motor should be 5mm (+/- 1mm).
Setting this distance is important to ensure that the belts will be centered correctly when installed.
To create a stackup of approximately 5mm, locate the following components and stack them as shown:
Laser cut spacer, from the Sundries Bag, in Kossel Common Core Component Kit
Vertex Cover Plate, from the Kossel Chassis Upgrade Kit
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.