Skip to main content

Site Navigation

Your Account

Choose Language


Time Estimate

Select a difficulty level for this entire task (including any prerequisite instructions). The difficulty ranking reflects the experience, physical dexterity, and risk involved.

Very easy

Does not require opening device.


Requires minimal disassembly and requires only basic tools like a Phillips or flat-head screwdriver.


Requires a fair amount of disassembly. This is a task that most people would not perform without instruction.


Requires significant disassembly and may require specialized tasks like soldering.

Very difficult

This task is considered quite challenging, may require specialized tasks like micro-soldering, and may risk damage to the device. If you can do this, people may call you MacGyver on occasion.

If your guide picks up where an existing guide leaves off, add the existing guide as a prerequisite to avoid having to write additional steps. Prerequisite guides will be displayed before this guide. Make sure that the prerequisite guides are in the correct order. You can change the prerequisite order by dragging the icons to the left of the guide's name.

  • 3 × Upper Vertexes
  • 3 × Nut Spacers
  • 3 × 360mm OpenBeam
  • 3 × Tension Pulley
  • 6 × MF83 Ball Bearing
  • 6 × Idler Sub Assembly Top/Bottom
  • 6 × Idler Sub Assembly Front/Back
  • 3 × Vertex End Caps
  • 3 × M3 30mm SHC Screws
  • 3 × M3 18mm SHC Screws
  • 6 × M3 Locknuts
  • 3 × M3 8mm SHC Screws
  • 39 × M3 Nut
  • 12 × M3 Set Screw
Add New

Your contributions are licensed under the open source Creative Commons license.