1
2
3
4
5
6
7
8
9
10
11
12
13
14
Introduction
Details
Guide Steps
Review
Quiz
Recheck the centering of the rail on the OpenBeam Extrusion.
One handy way to do so is to use the edge of a pair of calipers to measure the lip of the extrusion on the rail.
The rail width is 12mm, so there should be 1.5mm on each side.
Install the fastener stack, and tighten down each screw snugly.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.